Dual WBO2 to V2 over serial??

[ThatDudeOrion]

I'm considering purchasing a Flashscan V2 and one of the features that I really like about it is the advertised ability to connect WBO2 to the V2 over serial. During my research I haven't been able to find out if I can connect 2 WBO2's to the V2 both over serial. I'd like to have 1 for each bank and leave the other external inputs open for 0-5v gauge senders and things like that. I believe the V2 is advertised as having only one serial input, however I swear I've seen users, possibly joecar, talk about having dual WBO2 over serial but I can't find anything about how to do it, or which WBO2 sensors/controllers will work. All the tutorials, which are great, just focus on adding a single WBO2.

Since I am most familiar with the Innovate brand, is it possible, for example, to connect 2 LC-1's to the FSV2 both over serial? or is it necessary to use the dual channel LM-2 controller to have both WBO2 connected over serial?

Are there other WBO2 controllers that could make this work?

A walkthrough of what would be different about connecting 2 vs. 1 would also be appreciated
Thanks.

[minytrker]

You can run dual serial widebands but they have to be connected together. I dont know what all widebands will do this but the new LC2 will allow you to connect them together then plug one plug into the V2. There is only 1 actual serial plug on the V2.

[joecar]

+1

you can daisy chain 2 Innovate widebands...

For example, with the LC-1:

wideband #1:
SERIAL IN <-- terminator plug
SERIAL OUT --> SERIAL IN on wideband #2

wideband #2:
SERIAL IN <-- SERIAL OUT from wideband #1
SERIAL OUT --> null modem cable --> FlashScan V2

to link the two widebands, you use the short serial cable same as what comes with the LC-1 (with 2.5mm stereo style jacks at each end).

[joecar]

I don't remember about the LM-1 dual channel controller... doesn't it have a pair of serial in/out ports...?

[bimbleuk]

I was considering this with two MTX-L gauges.

Then I'm guessing you edit the calc_pid.txt file with something like the following? Sorry not very good at that bit yet I usually just copy others

*CLC-00-110
factor 0.5 1.5 .4 "{GM.EQIVRATIO}*({EXT.WO2LAM1}+{EXT.WO2LAM2}/2)"

[joecar]

You could do that... or you could use the WO2LAM that is the leaner.

[ThatDudeOrion]

Ok thanks for the info. Follow up question, can efilive log both wbo2 individually or am I forced to pick one or the other or an average like the previous poster wrote?

[joecar]

It logs both.

If you're logging using V2 BBL, then you might want to enable automatic logging of externa digital pids...

V8 S&T -> Devices -> Logging

see post #8 here: BBL-PIDs-V2

[bplumcrazy]

Does this work with the AEM widebands....... I tried searching and can't find anything

[joecar]

Does this work with the AEM widebands....... I tried searching and can't find anything

I don't think dual serial connection works with AEM...

( the wideband controller must know about it's sibling (i.e. id 0 or 1) )