Help please

[Moneypit]

I am trying to get set up to data log, if I understand right I pick my ECM and TCM from the list in the upper left hand box. This populates the right hand box with my PIDs, I then drag the PIDs I want to log into the lower left hand box to load into my V2. OK good so far now the problem I am having is it will not let me load them because it says it needs 140% of the avalible memory, I have gone into the V2 and erased the data in it and it showes empty so I should have enough room. I have read the manual and looked through the forum and can't figure it out Help please.

[joecar]

Are you using the V2's internal flash memory to store the ECM/pidlist...?

If so, you need an external SD card (plugs into SD slot in top of V2)... and you need to tell V2 to use the external SD card.

[Moneypit]

Yes I have figured that part out, the problem I was having was I had all the DTC discriptions turned on. I got the PIDs loaded and did some data logging, now I am trying to figure out how to view the logs.

[Moneypit]

Where can I find the directions for opening the logs and viewing them????

[joecar]

Start V8 EFILive Explorer, goto the Scan tab, click Home (observe which folder upper pane positions itself on), drag log files from lower pane (V2) to upper pane (PC/laptop); [ then, also, delete log files from lower pane ]... exit when done;

and then use V7 scantool or V8 scantool to view logs on PC/laptop.