Im sure im just doing something wrong, but when i try to scan and datalog, i can not connect to the vehicle. It recognizes the vehicle ecm but will not connect when trying to scan. Any ideas of whats going on or what im doing wrong?
Thanks,
Rich
Im sure im just doing something wrong, but when i try to scan and datalog, i can not connect to the vehicle. It recognizes the vehicle ecm but will not connect when trying to scan. Any ideas of whats going on or what im doing wrong?
Thanks,
Rich
If you have the tuning software open at the same time close it.
2005 1500 HD , Custom OS3 SD tune .
2006 Trailblazer
Dinosaurs and Plants gave their lives so that we may drive , long live fossil fuel .
The tuning software is not open.
I also just bbx data logged with my v2 so that is connecting fine.
Did you select controller in the scantool?
Try disabling the comm port, restart computer, then re-enable the comm port, and start up the software.
Post a screenshot showing the PIDs tab in the scantool.
Yes its the right ecm. I've tried it with 2 different vehicles and still the same thing. I will head out to my shop tonight and try to connect to my truck again and screenshot it.