Hi Guys, I've recently installed a 402 stroker in to my car. (VY SS UTE) and i purchased the ls1 to ls2 extension cables fom racetronix to extend the cam sensor wiring harness from the back of the motor to the front.
But shortly after the engine is running i get a P0343 DTC error logged for a CamShaft position sensor circuit high.
If i unplug the cable, i then get a circuit low DTC P0342.
I'm hoping that it's just a stuff up with the cable wiring, so im hoping someone might have a diagram of what the pin outs are on the Aussie LS1 wiring harness is as well as the LS1 & LS2 Cam sensors. (So i can make sure the wiring is incorrect to fix)
1 thing i had to do to the cable to get it to fit into my ls2 sensor, was to use a soldering iron to melt a slot in the plastic to allow the plug to go all the way in to the sensor. Just incase anyone asks, yes the connecter is facing the right way as it has the clip going over the top of the sensor thingo to lock into place.
P.S engine came out of another car and was working fine. So sensor should be okay.
Any help would be greatly appreciated.