I am trying Calc.VET after running with an AutoVE tuned OLSD setup for a while - MAF has been unplugged for ~2 years (but not many miles - < 5000).
First, just to be sure wo2 was still functioning and VE was close, I ran a couple logs with the AutoVE settings and got mostly .99-1.01 in BEN map so I think that's still working. Tune and log are attached.
Next, I created tune file for logging Calc.VET (without CL/LTFT) from the above, and logged (both also attached). The MIL came on somewhere around time 09:30:40. I pulled over and looked at DTCs. It set a P0101. MAF frequency seems normal? (except near end of log when it's zero - I turned off ignition while still logging). Is that also why the DTCs are not in log file?
So, can someone review the settings in the Calc.VET tune? I'm still reviewing but not seeing where I went wrong.
Also - Is the AFR too lean in the Calc.VET log? Is it safe to be logging for an hour like this? It's leaner than the AutoVE log.
The AutoVE logging history and vehicle specifics can be found here:
https://forum.efilive.com/showthread...toVE-questions
Thanks
-- Joe