Need to replace RJ12 jack for WB Serial

[joecar]

Yes, but its just a matter of finding one in the proper form factor that fits the V2 case.

Ben

Once they have the cable wires crimped in they fit.

[DURAtotheMAX]

Once they have the cable wires crimped in they fit.

No no I'm talking about the actual (female) jack on the V2 PCB itself...not the OBD cable side.

[joecar]

No no I'm talking about the actual (female) jack on the V2 PCB itself...not the OBD cable side.

Ah, the socket, not the plug... ok understood.

[DURAtotheMAX]

Just figured I would bump this up to the top...does anyone have a current/updated part number for the RJ45 port on the V2? IE, one that is sold individually on Mouser/DigiKey...

[DURAtotheMAX]

I just ordered a handful of different RJ45 jacks from DigiKey. Looking at the datasheets and taking measurements from the original V2 connector, Im thinking at least one of them will work.

When I get the connectors and have a chance to try them out, Ill post up the part number.

Ben

[minytrker]

Pretty sure 95501-2661 is what I used for the RJ45 socket.

[Blacky]

Just figured I would bump this up to the top...does anyone have a current/updated part number for the RJ45 port on the V2? IE, one that is sold individually on Mouser/DigiKey...

http://www.digikey.com/product-searc...1-2821&x=0&y=0
Regards
Paul

[joecar]

Also this: www.mouser.com/Molex/95501-2821

[DURAtotheMAX]

Ok I found the proper one that is in stock.

A-2004-2-4-LP-N-R

or AE10384-ND

I took my V2 apart and replaced the jack last night, works perfectly now, and now the OBD cable stays in!