Results 1 to 1 of 1

Thread: 3 bar Map ?

  1. #1
    Senior Member RandyWS6's Avatar
    Join Date
    Jan 2005
    Posts
    115

    Default C7-E92 3-BAR Map help

    Im installing a 3 bar map on my superchargered C7 and need someone to help me with the scaler / offset, please
    The 3bar MAP is a GM ZL1 (12592525), Any body know the 3 BAR scaler / offset for the C7's ?

    Factory MAP
    B2101- MAP Sensor Scaler (128.13)
    B2103- MAP Sensor Offset (-1.650)

    factory map
    Key on motor off 96 kpa
    Key on motor on 30 kpa (idle)

    Thanks,Randy
    Last edited by RandyWS6; January 9th, 2015 at 05:28 PM.
    2000 WS6 TransAm-M6 LS3 forged 422 cid. 4L80 FMVB ,4:22 Ford 9"-35 spline axles
    2014 C7 3LT-Z51 Corvette Stingray M7 , A&A Supercharger , Kooks 1-7/8" long tubes & X Pipe 615 rwhp & 560 rwtq


    http://community.webshots.com/album/259987907DcztOG

Similar Threads

  1. Tuned as a 2 bar MAP but is actually a 3 bar
    By barbermi in forum Gen III V8 Specific
    Replies: 2
    Last Post: March 22nd, 2012, 02:24 PM
  2. 2 bar fuel map ???
    By Slowrc in forum Forced Induction and Nitrous Oxide (N20)
    Replies: 14
    Last Post: November 14th, 2011, 03:40 PM
  3. COS 3.3 bar map only reading 2.5 bar
    By BAD BOB in forum FlashScan V2
    Replies: 0
    Last Post: August 8th, 2011, 11:27 AM
  4. 3 Bar MAP sensor doesn't work with 3 Bar scaling!
    By Redline Motorsports in forum General (Petrol, Gas, Ethanol)
    Replies: 23
    Last Post: April 27th, 2010, 04:21 PM
  5. Anyone know of a 1.5 bar MAP sensor?
    By mistermike in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: August 19th, 2007, 07:57 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •