Page 4 of 4 FirstFirst ... 234
Results 31 to 32 of 32

Thread: LML vane position at idle

  1. #31
    Lifetime Member Mitco39's Avatar
    Join Date
    Jan 2009
    Posts
    643

    Default

    Ive tried and with the tables we have access to I could not get it to do what I wanted. I know Kory is doing them and I know H&S does it, I am assuming there is extra tables in there (havent had time to look through mcc to see if they are listed with their software).

  2. #32
    Lifetime Member
    Join Date
    Feb 2007
    Posts
    517

    Default

    Here we are 5 years and some months later from the original post, and I have a 2012 I’m trying to get to keep the vanes open at idle. You can barely touch the throttle (not even enough to raise the engine RPM), and they will open right up to the open loop position table settings. Also, you can put it in reverse, and they will open but close in drive. It doesn’t make any sense to me. I could use some pointers if anyone has some guidance to help.

Page 4 of 4 FirstFirst ... 234

Similar Threads

  1. Vane position commanded vs. actual
    By 2013 Silverado 3500 in forum Duramax 2011+ LML / LGH
    Replies: 0
    Last Post: October 11th, 2013, 05:04 AM
  2. Min. turbo vane position?
    By IdahoRob in forum Duramax 06 LLY / 06+ LBZ & LMM
    Replies: 13
    Last Post: April 9th, 2007, 10:56 PM
  3. VVT Vane position
    By killerbee in forum Duramax LLY
    Replies: 2
    Last Post: September 18th, 2006, 03:58 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •