Originally Posted by
cindy@efilive
First off V7 software cannot be used with AutoCal. AutoCal customers can only use V8 software, and almost always only ever BBX to facilitate reading and flashing.
$0502 error message suggests that the required *.obj files are not located on the device. After you selected AL5 in the BBX box, did you PROGRAM that selection into your AutoCal?
There are a couple of ways to resolve this.
1. Have ATP send you the tune file within a Quick Setup. The Quick Setup has the ability to program all of the required configuration files for AutoCal at the same time as copying the tune to your device.
2. Select AL5 from the F5: BBX - F3: Tune menu by selecting the + button on the RHS of the screen, then right clicking on the Trans-controller and selecting AL5. Once selected, and all 3 columns of data are populated select the drop down arrow on the Program button and select Program Selections & Configurations Files (slower) to reprogram your AutoCal.
Cheers
Cindy