autove help please

**garyk1970** · February 1st, 2015

Joe;
I did save the log/file....I'll post up the info in the morning.... (I have better internet at work). I'm not sure what model arm...its only 6 months old with the gage....I have the 5v+ and a ground hooked up to Adv1 input and set pids to plx .....its off but I've been adjusting my counts...I'm just trying to get the tune in the ballpark and learn....
After I open the log file, no where can I find the page on the map to copy and paste to my ve....

**garyk1970** · February 1st, 2015

Originally Posted by 400ss

First you select the pids right? Then you do the log. Then stop the log and save it. When looking on the map you did you can changue the to view cell count or average of the input data

Yes, I've successfully logged and pasted to my he several times.....just my best log is corrupt and was hoping to recover it....
Joe: I know its not afrs....I'm not sure what the 10's are from? I know I didn't follow the instructions and it happened....it happened a few times....no matter what I do while viewing the log, can I get the 0.8-1.2's to come back

**johnv** · February 1st, 2015

I think you must have just opened the wrong Map, click on the MAP tab, then click on the A B C D E F G .... to display the different saved Maps,
you want the Ben Map so you can paste and multiply in your VE table.

**garyk1970** · February 2nd, 2015

No other maps made yet...when I try to copy and paste to my ve, they all read 500.....
This happens after I save a log and reopen it....

**400ss** · February 2nd, 2015

Copy with labels and paste and multiply with labels

**joecar** · February 2nd, 2015

Originally Posted by garyk1970

No other maps made yet...when I try to copy and paste to my ve, they all read 500.....
This happens after I save a log and reopen it....

What does the map look like (post screenshot)...?

When you paste, do you paste-multiply...?

**joecar** · February 2nd, 2015

Are you trying to follow the AutoVE tutorial...?

If so, then there are a few things you need to address:
- PE Enable needs to be edited to enable easier,
- OL STFT trimming needs to be disabled (B4205),
- log GM.EQIVRATIO instead of GM.AFR;

also things will be easier if you do the following:
- use EQR for fueling units (rather than AFR),
- use g*K/kPa for VE units;

To see examples of maps, look at post #1 of the Calc.MAFT thread... this is an updated AutoVE (ignore the part about calculating/pasting the MAF table)... you can tailor it to use only wideband.