Tried flashing a 09 c&c, receiving a $0340 code. Truck in no start condition. Suspect a dead ecm. Any way to know for sure?
Tried flashing a 09 c&c, receiving a $0340 code. Truck in no start condition. Suspect a dead ecm. Any way to know for sure?
Probably a protected ECM....see here.
http://download.efilive.com/Tutorials/PDF/Cummins%20BootRSA%20Patch%20User%20Guide.pdf
If you can reflash the stock tune back in then that is your problem.
I no longer monitor the forum, please either post your question or create a support ticket.
I have bootloader rev 1000601, I will try the patch.
Where do I download the rsa patch for bootloader 601?
The pre-release software contains the patch
Les Szmidt
2007 5.9 Dodge Ram
2014 Ram 3500 Aisin tuning Emissions Equipped
EFI Live Cummins BETA Tester
Silver Bullet Tuning
silverbullettuning@gmail.com
www.youtube.com/ljszmidt
http://www.facebook.com/SilverBulletTuninig
Thanks Les!
Can I use the base tune I read out of the truck? In v7.5 it says ok to flash but in v8 it says DO NOT FLASH.
Did u check for firmware.. In v8
Last edited by Evil R8; February 15th, 2015 at 09:52 PM.
As suggested you need to update all your software, from memory the DO NOT FLASH warning was removed from later versions of the software. The tune you read out of the ECM before patching it will be fine to use once the ECM is patched.
I no longer monitor the forum, please either post your question or create a support ticket.
Thanks guys, applying the patch solved the problem.