Results 1 to 6 of 6

Thread: E37 Bench harness Pins

  1. #1
    Lifetime Member
    Join Date
    May 2012
    Posts
    303

    Default E37 Bench harness Pins

    Searched on the help- bench harness tutorial info, and didnt find the info for the E37, wich are the pins needed on a bench harness for the E37..

    im using 19-switched ignition, 20-battery, 73-switched ignition, 43 and 44 CAN signal on C1, on C2 73-ground, is this correct?? cant read a E37 ECM, maybe the ecm is bad. just want to check

  2. #2
    Lifetime Member
    Join Date
    Aug 2010
    Posts
    1,934

    Default

    There are probably many ways to build a Bench Programming Harness for the E37. The PDF attached below is just one possible way to do it.

    I would use only the C1 / X1 / J1 connector (call it what you will) - similar to an E38 setup.
    Attached Files Attached Files

  3. #3
    Lifetime Member
    Join Date
    May 2012
    Posts
    303

    Default

    Thank you very much sir

  4. #4
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Taz, thanks.

  5. #5
    New Member
    Join Date
    Feb 2015
    Posts
    2

    Default

    hi is possible y send me the e37 pinout , or the ecm shematic.
    thanks

  6. #6
    New Member
    Join Date
    Jun 2011
    Posts
    4

    Default

    I've tried this one and others on 3 different ECMs and can't connect to any of them. Any ideas?

Similar Threads

  1. Bench harness question
    By pavetim in forum Duramax LB7
    Replies: 3
    Last Post: June 12th, 2012, 11:31 AM
  2. Bench Harness?
    By GAMEOVER in forum IL6,IL5,IL4 Atlas Engines - P12 PCM
    Replies: 3
    Last Post: January 31st, 2009, 10:33 AM
  3. bench harness
    By minytrker in forum General (Petrol, Gas, Ethanol)
    Replies: 6
    Last Post: June 15th, 2006, 04:09 AM
  4. Bench Harness
    By Biodiesel66 in forum Duramax LB7
    Replies: 1
    Last Post: May 3rd, 2006, 08:34 PM
  5. bench harness
    By madprof01 in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: September 21st, 2005, 02:25 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •