With 70% throttle ppen nearly 540 whp
Not bad....
"All that is needed for the triumph of evil is that good men do nothing..."
His problem was fixed a while ago!!
"All that is needed for the triumph of evil is that good men do nothing..."
Having the same problem on an engine dyno...what was the resolve?
Any word on the solution?
Any updates on this ?
I had the same problem with my C7 with a A&A supercharger, the BARO codes that you have and had to cut the wires that goes to the MassAir for the BARO and had to wire a plug that fit my factory MAP sensor, that i had to replaced with a 2.5 bar map on the intake for boost, and tie wrap it under the hood in free air and now the code are gone for good been 2 years now. If you need to know witch wire to cut i can take some pics tomorrow and send them to you or post them .
2000 WS6 TransAm-M6 LS3 forged 422 cid. 4L80 FMVB ,4:22 Ford 9"-35 spline axles
2014 C7 3LT-Z51 Corvette Stingray M7 , A&A Supercharger , Kooks 1-7/8" long tubes & X Pipe 615 rwhp & 560 rwtq
http://community.webshots.com/album/259987907DcztOG