Help with tune...NO PEDAL

[kylelavergne]

I just finished this new tune for my truck. when I flash truck runs great but has no pedal response at all. I can idle the truck up & down with the scan tool but the foot pedal does not work at all. what did I do wrong? please help asap!!


Tune I made
LS1BKyle_Current Tune.ctz


Factory tune for my truck
2006 Chevrolet Silverado Truck Automatic LQ4 6.0 Litre (12587811).tun

[joecar]

OS is different than stock.

Start again, but this time copy your edits (by using a script) in to the stock file (rename it first).

[kylelavergne]

I know the OS is different joecar. my truck was tunned with efi live by someone else before I bought the software so I never had my stock file. this is a stock file for a truck like mine from a stock file website. the OS for the tune I made is correct. Its something I edited within the tune I think just cant figure out what.

OS is different than stock.

Start again, but this time copy your edits (by using a script) in to the stock file (rename it first).

[joecar]

Ok, start again, start with the stock file of the different OS, copy your edits into this.

[kylelavergne]

same thing. it has to be a table I edited wrong I just cant figure out which 1

Ok, start again, start with the stock file of the different OS, copy your edits into this.

[joecar]

Connect your V2 to your PC (so that the tune file shows the red ETC folder) and compare the ETC tables from each of the tune files above.

[kylelavergne]

there is a big difference. do you think I maybe increased it a little too much?

Connect your V2 to your PC (so that the tune file shows the red ETC folder) and compare the ETC tables from each of the tune files above.

[joecar]

there is a big difference. do you think I maybe increased it a little too much?

Yes, a little too much will cause unresponsive throttle, and a little more than that will cause the PCM to shutdown and brick itself... all in the name of protecting the user from the worst possible scenario throttle mishap.

[kylelavergne]

ok I will change it back to the factory setting & give you a update asap!

Yes, a little too much will cause unresponsive throttle, and a little more than that will cause the PCM to shutdown and brick itself... all in the name of protecting the user from the worst possible scenario throttle mishap.

[kylelavergne]

ok I updated both ETC tables to factory and flashed truck. same outcome. truck runs great, starts up fine, put foot on gas pedal and nothing happens.

Yes, a little too much will cause unresponsive throttle, and a little more than that will cause the PCM to shutdown and brick itself... all in the name of protecting the user from the worst possible scenario throttle mishap.