O.K., so I reboot my laptop this spring, so It is completely empty. I download the new latest software download and get it setup. I then read current tune from last fall from my pcm in the car, and save the file into my new software so I can modify it. I change the IAT/VE table correction from 1.30 to 1.00. I change my rev liter to a lower rpm, and load it back into the car. That's it!

NOW, my injector duty cycle is at 106%, my last data log from last year, I was at 70%. What is the deal?????????? Can this effect anything? Should I care?
I run 96 lb injectors with a injector driver at 45 psi fuel pressure. I know they are not maxed! What changed??

Aslo, my injector flow rate(B4001) table reads from 12.1 TO 13.6 from top to bottom. The same as last year?

WHAT COULD THIS BE?????????