LNC-2000 Retard Pid

[Tre-Cool]

Trying to create a pid for the amount of timing being pulled from the LNC-2000.

According to the lnc-2000 manual the signal is a linear voltage from 0.2 to 4.8
Timing Retard 0-15 degrees

I have setup the following and it's close to what I think it should be doing seeing as we have 4 degrees of retard set and the highest point it hits is 4.

*CLC-00-2052
V 0.2 4.8 .2 "{EXT.AD1}"
Deg 0 15 .2 "{EXT.AD1}/2*5"

Is that correct?

Annoyingly someone from LPE posted that it's a 0v-3v. (this is correct. I was reading the wrong wire)
http://ls1tech.com/forums/nitrous-ox...l#post18462221

BUT, the device is constantly outputting 0.2v when the controller is on so I think he is talkin about a different device