6 speed not updating current gear fast enough
After my track outing today, I have found that the current gear is not updating quick enough after a shift. It is making rpms go north of 4200rpm because it will not command the next gear change until the current gear is updated. I am going to include a tune file and a snapshot of the log. Tune is basically stock with WOT shift points set way low trying to get a gear change. Anybody run across this before?
I had mine act weard like that then I dropped the MPH and RPM down low too. Shifted fine when I used the tap shifter and changed gears at about 2500-3000 RPMs.
Seemed to me that trying to get it to shift below 2000 or so RPMs at WOT made it refuse to shift.
2008 Chevrolet 3500HD DRW LTZ
285/75/17 Nitto Dura Grapplers, 4.56 gears, Front and rear ARB lockers, Efi Live tuning by me, Raptor 160 LP, Cognito 4-6 NTB Lift, 4" Exhaust, Built Trans by Mike L.
Sold - 2004 LB7 Duramax, EFI Live with DSP5 Tune
stage 4 SC transmission, 265/70/16 tires
I had mine act weard like that then I dropped the MPH and RPM down low too. Shifted fine when I used the tap shifter and changed gears at about 2500-3000 RPMs.
Seemed to me that trying to get it to shift below 2000 or so RPMs at WOT made it refuse to shift.
2008 Chevrolet 3500HD DRW LTZ
285/75/17 Nitto Dura Grapplers, 4.56 gears, Front and rear ARB lockers, Efi Live tuning by me, Raptor 160 LP, Cognito 4-6 NTB Lift, 4" Exhaust, Built Trans by Mike L.
Sold - 2004 LB7 Duramax, EFI Live with DSP5 Tune
stage 4 SC transmission, 265/70/16 tires
Posting Permissions
Reply With Quote