Results 1 to 6 of 6

Thread: TPS vs RPM

  1. #1
    Member
    Join Date
    Dec 2006
    Posts
    96

    Default TPS vs RPM

    My 2000 Corvette is heavily autocross-ed (BS) and occasionally in 2nd gear, the car will not accelerate quickly when the tach is around 3500-4000 rpm. Since the season is over I was looking at several log runs. In checking the tune I noticed C3906 might be limiting my throttle from opening faster, I was wondering if I would be better off increasing the upper limits between 2800 rpm and 4800 rpm and having it go to 95 or 100% from 4800 and above?

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Are you seeing any TPS DTC's...?

    Try what you said and see what it does.

  3. #3
    Member
    Join Date
    Dec 2006
    Posts
    96

    Default

    I will make the change and see if any DTC get set.

  4. #4
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    If you see any TPS DTC's then table C3906 is being exceeded... of course check that the TPS DTC's are enabled in C6001.

  5. #5
    Member
    Join Date
    Dec 2006
    Posts
    96

    Default

    There were three that we not reported so I turned them back on. P0121, P0122 and P0123

  6. #6
    Member
    Join Date
    Dec 2006
    Posts
    96

    Default

    Ran a scan last night and there were not DTC's tripped. Also I noticed it felt like an improvement in mid RPM acceleration. When time permits, I will look at the scan and see if there was measurable difference as I ran a similar scan just before I flashed the changes.

Similar Threads

  1. E40 idle RPM won't go below 800 RPM
    By ACCLR8N in forum Gen IV V8 Specific
    Replies: 5
    Last Post: June 4th, 2014, 07:46 AM
  2. SAE TPS and actual TPS opening %?
    By O1Z06 in forum Petrol / Gas
    Replies: 6
    Last Post: February 2nd, 2011, 03:28 AM
  3. Alpha N (TPS Load) help... noisy TPS signal?
    By Tomato in forum Gen III V8 Specific
    Replies: 4
    Last Post: July 4th, 2008, 09:22 PM
  4. Knock sensor multiplier (6244, 45, 50 & 55) TPS, RPM and
    By ringram in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: September 8th, 2007, 03:59 AM
  5. VE Multiplier vs. TPS vs. RPM table, with non-linear TPS...
    By SSbaby in forum General (Petrol, Gas, Ethanol)
    Replies: 17
    Last Post: November 7th, 2005, 10:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •