Results 1 to 2 of 2

Thread: Vz ls1 tps out put

  1. October 20th, 2015 #1
    JCA
    JCA is offline
    Member
    Join Date
    Aug 2006
    Posts
    90

    Default Vz ls1 tps out put

    Hi guys I trying to find a tps out put input on a vz ls1 pcm to send a tps signal to a ams2000 I tryed jumping of the tac module but went in to safety mode
    Reply With Quote Reply With Quote
  2. October 22nd, 2015 #2
    JCA
    JCA is offline
    Member
    Join Date
    Aug 2006
    Posts
    90

    Default

    All good I used a pick up from the pedal sensor
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Idle A/F ratio rich, OK when put in drive, LS1 Trans AM
    By RamAir in forum Gen III V8 Specific
    Replies: 0
    Last Post: November 10th, 2012, 01:57 AM
  2. SAE TPS and actual TPS opening %?
    By O1Z06 in forum Petrol / Gas
    Replies: 6
    Last Post: February 2nd, 2011, 04:28 AM
  3. Help! How to put tunes on my v2
    By LS1FREEK in forum FlashScan V2
    Replies: 25
    Last Post: April 11th, 2010, 10:30 AM
  4. Alpha N (TPS Load) help... noisy TPS signal?
    By Tomato in forum Gen III V8 Specific
    Replies: 4
    Last Post: July 4th, 2008, 10:22 PM
  5. VE Multiplier vs. TPS vs. RPM table, with non-linear TPS...
    By SSbaby in forum General (Petrol, Gas, Ethanol)
    Replies: 17
    Last Post: November 7th, 2005, 11:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules