Page 3 of 3 FirstFirst 123
Results 21 to 23 of 23

Thread: Autocal and external wideband using serial comms

  1. #21
    Junior Member
    Join Date
    Mar 2016
    Posts
    18

    Default

    Ahh OK. But, only if its serial. Not analog data. Correct?

  2. #22
    Junior Member
    Join Date
    Mar 2016
    Posts
    18

    Default

    Quote Originally Posted by Tre-Cool View Post
    well you really only need the tx from the wideband on the rx of the autocal unit and you'll get wideband data
    Got everything hooked up from the Innovate LC2 to my Autocal, wired to the RX/Ground...not receiving any data. Is there anything special in EFILive i need to add other than the Serial WB PIDs?

  3. #23
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Did you configure FSV2 to read your wideband...?

    See post #3 here: Setting-up-a-FSV2-from-scratch

Page 3 of 3 FirstFirst 123

Similar Threads

  1. Replies: 13
    Last Post: July 14th, 2012, 02:07 AM
  2. How to: Adjust External Calc: Wideband O2 Setting form my .?
    By Earl H in forum General (Petrol, Gas, Ethanol)
    Replies: 60
    Last Post: November 23rd, 2009, 12:59 PM
  3. HELP! No external voltage!
    By gotabav in forum General (Petrol, Gas, Ethanol)
    Replies: 15
    Last Post: May 13th, 2008, 09:52 PM
  4. External input
    By heavymetals in forum External A/D inputs
    Replies: 4
    Last Post: May 2nd, 2006, 03:44 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •