Head Cam Intake ls1 2002 trans am

[Jetmech442]

Also, I have the wideband going to straight power and to make sure it does not kill the battery, I disconnect the battery and reconnect it every time I start if for right now. Could this take away the calibration of the wideband?

The calibration is only lost if power is provided when the wb is unplugged.

The wb should be wired Exactly like the pic below. Relay grounds, everything. This is absolutely critical. If not, then you always have an unknown to work about.

Can you post a pic of the wb log so I can look at it at work?


Sent from my Nexus 6P using Tapatalk

[Jetmech442]

BTW good find on today intake bolts. Mine loosened a we bit after my first couple Heat cycles too

Sent from my Nexus 6P using Tapatalk

[oreobadr]

What can I hook it to so that it turns on with the ignition? Could I attach it to the alternator power? or do I have to splice it into something??

Also I cant post anything until tonight because I am not next to my computer. I am about to go get a can of carb cleaner and see if I can find some more vacuum leaks, and thanks haha, I knew something must be leaking but I couldnt find it.

Lastly, when I rev the throttle really fast I can almost hear a whistling noise and one time it even backfired through the throttle body. Could a crack in my pcv valve tubing cause a large vacuum leak?

[joecar]

Multiply your MAF table by 1.4, and take another log.

[Jetmech442]

Alternator power wire is always connected to battery,so no .slice into the harness is best.



Sent from my Nexus 6P using Tapatalk

[joecar]

Connect relay pin 86 to ignition switch RUN feed.

[joecar]

...

Lastly, when I rev the throttle really fast I can almost hear a whistling noise and one time it even backfired through the throttle body. Could a crack in my pcv valve tubing cause a large vacuum leak?

That sounds like a leak.

[oreobadr]

when you say MAF table, are you refering to the maf calibration table?

[oreobadr]

Also, where can I run the wire that is inside of the engine bay as I do not have the wideband entering into the cockpit of the car.

Lastly, why did you say multiply by 1.4? was that to mimic the adjustments made to the IFR table?

[oreobadr]

Also just took a can of carb cleaner and sprayed it everywhere. I do not think it is leaking and I cant find that source of the whistling noise.