Valet Mode For CSP5 Setup

[EverydayDiesel]

Hello,

Not often but sometimes I am forced to let someone else drive my truck. (like for inspection)

Is there a way I can make the truck a dog to drive and cut the power down to below stock? I will soon have compounds on the truck.

I was thinking the easiest way to do this is to level off the "Petal position To Desired Fuel" table so that


Take this table



And make it look like this?



Is this reasonable to do?

[2007 5.9]

Easiest is to use the boost/fuel limiter table

[EverydayDiesel]

thanks! I see the default is 200 for this table across the board. Would you have a recommendation on what number to set this to? 50 or 100 maybe?

what happens to the tune if they unplug the csp5?

[2007 5.9]

Default isint 200...that has been modified from stock.

It's best to log fuel rate at the power level you want to limit at and use that as your table value

[2007 5.9]

Tune remains the same when switch is unplugged.

[EverydayDiesel]

Default isint 200...that has been modified from stock.

It's best to log fuel rate at the power level you want to limit at and use that as your table value

Crap. This tune for the 6.7 from tune file depot has it as 200. I guess it is not a stock tune :/

http://www.tunefiledepot.com/calibra...-55350435).ctz

[arinkuddy]

No I think its fine. I just quickly looked and all the 6.7 tunes I looked at had the boost limiter table at 200 across the board. Unless all of the stock files from the depot are modified, its prly stock

[EverydayDiesel]

Thanks, I appreciate you looking!

[2007 5.9]

I was thinking you had a 5.9 file. Sorry for the confusion

[EverydayDiesel]

I assume CMDFUELU or CMDFUELB is what I am looking for here.

What is the difference between "main injection quantity uncompensated" vs "main injection quantity with balanced rates"?