Calc vet.

[dirtymaxlb7]

I've looked over and over cant find what I'm doing wrong every time I try vet table log strange numbers like .1-.6 anyone have any ideas TIA

[joecar]

Post your:
- calc_pid.txt
- tune file
- log file

and some pics of your map.

[dirtymaxlb7]

pid_info.txt Log_0001.efi....DAN.efi dans curent 6-17-15.ctz

[dirtymaxlb7]

hope that worked

[joecar]

Your EXT.WO2LAM1 pid is pegged at 1.7... your wideband is not working.

[dirtymaxlb7]

wow im sorry was so sure i did something wrong i didnt even look at that had the blinky light on v2 thought all was grand

[dirtymaxlb7]

wo2 seems to be working but still giving me same numbers and it was working in other logs as well i must have sent one it wasn't is possible i need to configure them differently i'm using inovate lm2 (which apparently i could have used a much cheaper version and got same result maybe less confusing)

[dirtymaxlb7]

Log_0002.efi

[joecar]

Log_0002.efi

Ok, it looks like wideband is now working... it shows lean on throttle close, maybe turn off DFCO during tuning.

Post screenshots of:
- your MAF map (SELBEN vs MAFFREQ Hz),
- your VE map (VET g*K/kPa vs MAP kPa vs RPM).


You don't have enough data, you need to drive around for about 20-30 mins, use steady /progressive throttle, don't jerk the throttle.

[joecar]

BTW: when throttle opens significantly, you get bare any PE...

check this:
- B3616: set to 65% below 3200 rpm, 35% above 3200 rpm.
- B3609, B3610: set both to 0.020 seconds.
- B3613: make sure this is less than 100 kPa (set it to either 50 kPa or 70 kPa).
- B3618: set this to EQR 1.175.