Hello Efi Live members! Wondering if you can help me with this question.

I have had my V1 cable for several years now, licensed it for several of my vehicles over the years, and it has worked well for me.

Fast forward to today. I have a 2003 Chevy Duramax LB7 which I have licensed both the TCM and PCM to my cable. I have put a custom OS on it and it has worked great for at least 5+ years. Recently mice built a nest in my underhood fuse panel, chewing the wiring and causing everything to go haywire in the truck. Wiring was repaired where needed. Right now if I turn the key to "on" it will start cranking the truck and either start and run or then stop cranking and then the "start" position will not work.

Troubleshooting with the GM schematic and shop manual tells me its a PCM issue. Wiring appears to be ok, Park neutral switch is ok, etc. I have tried unplugging both batteries and letting the pcm sit for a few hours but it does the same thing when plugged back in. I have tried reflashing the pcm, it takes a tune but the issue isn't resolved either.

Long story short, I have bought a used duramax LB7 PCM that I wish to flash my current VIN and tune onto in order to get my truck running again. Will I need a new license or because its the same VIN for the same truck, will I be ok to use my current license? If I need to order a new license from EFI in advance due to the time zone difference and I'd like to know before the ECM comes in Friday.