Another Question for the V2. I have the V2 set up for running my innovate lm2 through the serial port and i have used this in my truck for a few years now and it works great. I have a bench harness that i made and i use it for full flashing . I set it up yesterday on a spare 0411 pcm and i connected my lm2 through serial with my sensors connected to the lm2 and i can see the values in the V2 screen comming in through the serial connection reading both 20.9 and displaying free air so that is normal as they are in free air but i cannot see the values in the data on my laptop, everything seems to be set up as it is in my truck , i am getting like wierd numbers like 50 or 80 or nothing at all in both channels . I did however delete my old pid selection that i did use while logging in my truck so i made a new pid selection using both external wideband afr pids. Is it something i am not doing right on the bench, is it because i am using a different pcm , is it because there has to be a live working fluctuation o2 signal through serial for the signal to pass through the v2 and then to the software . As i said the v2 is seeing the serial signal from the lm2 but not getting to the software. I am going to try it in my truck this morning and reinstall my o2s in the y pipe just to be sure it still works ok as it always has. I have to get this sorted out as i have to connect to my friends truck that i installed two mtx-L innovate afr gauges in so we can rework his tune . Thanks. Eric