Not a "tuning" question, but I figure all the savvy Cummins experts will be more active in this section:
New to EFI Live, and I am hoping someone on the forum has had success doing this. I want to use Cummins Insite to read data and DTCs from the CM2100A and CM2200 ECMs like I already do with any Class 7 Cummins CM550, CM850, CM2250, etc. Has anyone had success doing this? I used EFI Live to flash the changes I wanted into the ECMs via CAN, but the J1939 Datalink does not communicate with either ECM using Insite (get the "Contact distributor for subscription" message). Datalink traffic on J1939 is normal as measured with Cummins Adapter Validation, and I can communicate with both ECMs on J1939 using Calterm.
Thanks!