Results 1 to 3 of 3

Thread: LS Wrangler P0171 and P0174 Help

  1. #1
    New Member
    Join Date
    Jan 2017
    Posts
    1

    Default LS Wrangler P0171 and P0174 Help

    Hello all,
    I'm looking for help troubleshooting a Wrangler conversion. I have a 2008 Wrangler with a 2015 6.0l L96. The engine has 12 miles on it, I got it from a local salvage yard complete with harness, pedal, and E38. It starts and runs, and drives, but gives me P0171, P0174 and occasionally P0300 codes. So far, I haven't driven it any real distance.... just around the block, maybe a mile or two.
    Expecting to find a vacuum leak or an intake leak I have smoke tested the intake, as well as used propane, water, and carb cleaner, but was unable to effect idle at all. I smoke tested the exhaust and found no leaks there either. I have not done a fuel system volume test or pressure test as I do not have the tools (or knowledge) to do it.

    I recorded a couple of sessions hoping someone more experience than I could have a look and possibility point me in a direction.
    The first recording is pretty much the condition it has been in since I got it running. The second is with the MAF unplugged, which does not have the lean condition. Does anything jump out to any of you? Any suggestions of how to proceed?
    E38_T43 33-4-17_t2.pld
    E38_T43 33-4-17_MAF Unplugged.pld

    Thanks for any insight you can lend!

    -Chris

  2. #2
    Lifetime Member
    Join Date
    Dec 2014
    Posts
    230

    Default

    This is pretty basic and you have almost answered your own question. Its bad one way and good another, what does that tell you?

    How is the maf setup in the intake? Is it the correct maf? Is the scaling correct? Have you tuned the maf for the intake? Is it installed in the correct orientation? Have you verified you base tune is correct for the engine, injectors, maf...........

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    +1 what Team208MS said...

    post pic of MAF duct/plumbing.

Similar Threads

  1. DTC P0300 and P0174
    By 68problemchild in forum E37, E38 & E67 PFI ECM's
    Replies: 18
    Last Post: November 8th, 2016, 10:39 AM
  2. P0171 & P0174 SC 2010 Camaro
    By opcode in forum E37, E38 & E67 PFI ECM's
    Replies: 14
    Last Post: July 26th, 2016, 09:19 AM
  3. P0171 and P0174 codes. Please help
    By JoshH in forum E37, E38 & E67 PFI ECM's
    Replies: 7
    Last Post: November 3rd, 2009, 04:23 PM
  4. threw a p0171
    By birdman in forum Gen III V8 Specific
    Replies: 3
    Last Post: July 27th, 2008, 07:31 PM
  5. P0171, P0174 Banks 1,2 lean
    By limited cv8r in forum General (Petrol, Gas, Ethanol)
    Replies: 4
    Last Post: September 5th, 2006, 07:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •