Have been data logging for the last 4 days without any issues but now when I use the V7.5 Scan tool it will connect to the ECM all good and go to start recording and it is all good starts recording but then no actual data is shown. If I go to the console tab it just shows it constantly loading the pids. Will run through them and say connected ok then starts again. I had also noticed if I just click monitor data it would just go to pause and wouldn't monitor this has been happening for ages. The strange thing is I can log data using V8? Have shutdown restarted computer but no change. Any of the programmers give any advice? All firmware is update and running latest versions.