Results 1 to 3 of 3

Thread: LFX E39 no 02 sensor activity

  1. #1
    New Member
    Join Date
    Apr 2017
    Posts
    2

    Default LFX E39 no 02 sensor activity

    I'm hoping some of you really smart guys might point me in a direction that will help. Details,

    2014 LFX conversion into 2002 Miata. Custom stand alone harness. Front 02 sensors only. E39 processor same base tune that has worked fine on other conversions. Starts and warms up fine. Wont go into closed loop due to no 02 activity. Scan tool shows sensors sitting on .015 volts. Very erratically it will jump up to .7 or .8 and engine will smooth right out. 2 different sets of sensor. 1 set new, 1 set used, known good from perfectly running car. 2 different pcm's with same base tune. I have pinned back both connectors to PCM and all wires have continuity and are where they are supposed to be. Eventually it will start throwing lean codes, misfire codes and 02 low circuit codes. When i use the scan tool to do the 5 step 02 tests they both pass all tests. If I pull sensors and ground them to the engine and turn on the key I get no heat at all. I have battery voltage at the pink and black wire at the sensor with key on.

    I have stripped down the harness and checked for broken wires. Fuel pressure is 58 psi at the DI pump and anywhere from 600 to 1200 at the injector depending on rpm. Right angle elbow off throttle body. Maf is 7.5 inches from throttle body. I moved it back to 12 inches and it improved idle but didn't change anything else. I have had a helper wiggle connections and plugs but no consistent change for the better.

    Pulling out what's left of my hair. Customer car and it should have been delivered ages ago. Checked basics. Compression. Leak down, etc. Engine has less that 5k miles. Any suggestions welcome. I'm going to post on HP Tuners and LS1 as well. Thanks for any thoughts.

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Recheck O2 sensor wiring in harness and in O2 pigtail.

  3. #3
    New Member
    Join Date
    Apr 2017
    Posts
    2

    Default

    Just confirmed config against stock unmodified harness. All colors are in the appropriate places. Os sensor wires are as delivered from GM.
    Last edited by V8R; September 22nd, 2017 at 04:07 AM. Reason: add

Similar Threads

  1. 3.6 sidi lfx
    By jfclubby in forum E39, E80, E82 & E92 SIDI ECM's
    Replies: 4
    Last Post: October 22nd, 2015, 01:13 PM
  2. E39 V6 Alloytec SIDI LF1/LFW/LFX throttle max %
    By 3L SIDI in forum E39, E80, E82 & E92 SIDI ECM's
    Replies: 4
    Last Post: November 20th, 2013, 11:21 PM
  3. E39 lfx kr
    By Rhino79 in forum E39, E80, E82 & E92 SIDI ECM's
    Replies: 38
    Last Post: February 13th, 2013, 02:05 AM
  4. 2012 Camaro LFX
    By sycraft in forum E39, E80, E82 & E92 SIDI ECM's
    Replies: 13
    Last Post: November 7th, 2012, 08:37 AM
  5. Replies: 4
    Last Post: January 2nd, 2012, 07:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •