Results 1 to 3 of 3

Thread: 6l80e code p01825

  1. #1
    Member
    Join Date
    Aug 2006
    Posts
    90

    Default 6l80e code p01825

    Done a l98 /6l80e conversion but keep getting code p1825 in the tcm and is stuck in limp mode i ve swaped the range switch over -no good tryed a different tcm - same code, disabled code in tune and then we have no drive at all i noticed the tcm has a p/n out put on pin 3 i wonder if this needs to go to the ecm and then the ecm sends a signal back to the tcm via can bus?

  2. #2
    Lifetime Member
    Join Date
    Aug 2013
    Posts
    735

    Default

    Might be a mis-alignment between the transmission selector lever and the transmission range switch.

  3. #3
    Member
    Join Date
    Aug 2006
    Posts
    90

    Default

    It feels like it dropps on to the gear nice against the detent i might drop linkage off to confirm they have modded the column selector to mate up to the 6l80e

Similar Threads

  1. swapping Camaro 6l80e to Vette 6l80e
    By secrt007agt in forum General
    Replies: 0
    Last Post: January 31st, 2016, 03:43 AM
  2. Odd 6L80E Behavoir
    By Webbs in forum 6 speed/8 speed RWD/FWD Transmission Tuning (incl T43, T76, T87)
    Replies: 10
    Last Post: January 30th, 2013, 01:38 PM
  3. NEED HELP , Trying to calibrate 6l80e.
    By SkywayPerformance in forum 6 speed/8 speed RWD/FWD Transmission Tuning (incl T43, T76, T87)
    Replies: 11
    Last Post: March 12th, 2012, 07:37 AM
  4. Is it possible to put the LS7 and 6L80E together
    By Brads_rs in forum Gen IV V8 Specific
    Replies: 16
    Last Post: May 17th, 2011, 01:49 AM
  5. Code P062F and Code P0633 Help
    By Airtime in forum General (Diesel)
    Replies: 6
    Last Post: September 28th, 2009, 12:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •