Results 1 to 3 of 3

Thread: 2012 6.2 Denali LS9 Cam Swap help

  1. #1
    Member TorqueMonster007's Avatar
    Join Date
    Aug 2013
    Posts
    83

    Question 2012 6.2 Denali LS9 Cam Swap help

    Trying to help a buddy out since I have a V2 Scan/Tune to get his Denali up and drivable after he did a complete DOD delete and LS9 cam swap, lifters, ect... The correct cam, cam gear, front cover and sensors(spliced according to kit) are installed and correct. It also took the crank relearn just as it should. AFM is turned off in the tuning as well as matching the DTCs to disabled to match an ls3 Camaro in terms of cam sensor and the afm solenoids to not reported. It will crank and idle fine and drives well with no issues but once he goes to put gas in it (takes cap off even though not running and tries to refire after pumping) it will struggle to crank. The purge solenoid at the intake is then going crazy. You can take the hose off the intake and it fire perfect every time as it should. Am I missing something in the tuning somewhere? This is just to get him going without a hiccup till he can get it tune a dyno and a tuner. Also, its just intake, exhaust and DOD delete/LS9 cam. factory manifolds and cats
    2024 3500HD (SRW) Duramax Denali Reserve
    2021 Ram 4500 Limited (Horse Hauler)
    2016 LML 2500HD Duramax High Country with a little help
    2022 Yukon Denali

  2. #2
    Member TorqueMonster007's Avatar
    Join Date
    Aug 2013
    Posts
    83

    Default

    Also note that I did edit the Minimum Enable/Disable Vacuum tables that matched the camaro as well but didn't honestly think they were necessary to be changed?
    2024 3500HD (SRW) Duramax Denali Reserve
    2021 Ram 4500 Limited (Horse Hauler)
    2016 LML 2500HD Duramax High Country with a little help
    2022 Yukon Denali

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    see my response in your other thread.

Similar Threads

  1. 2012 6.2 Denali LS9 Cam Swap help
    By TorqueMonster007 in forum Gen IV V8 Specific
    Replies: 7
    Last Post: December 12th, 2017, 06:37 AM
  2. 2012 camaro with TH400 swap
    By bplumcrazy in forum E37, E38 & E67 PFI ECM's
    Replies: 3
    Last Post: May 29th, 2015, 05:16 PM
  3. 2012 Camaro Mangacharger Cam And Exhaust - Check this tune
    By HellKnightHicks in forum Gen IV V8 Specific
    Replies: 8
    Last Post: December 11th, 2014, 06:45 AM
  4. 2012 Camaro SS gear swap, speedo calibration?
    By slowhawk in forum E37, E38 & E67 PFI ECM's
    Replies: 2
    Last Post: December 29th, 2012, 02:04 AM
  5. Need Help with VVT cam tuning in Sierra Denali
    By motorhead in forum Gen IV V8 Specific
    Replies: 0
    Last Post: October 16th, 2011, 09:27 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •