Results 1 to 2 of 2

Thread: Trouble after DSP5 upgrade

  1. #1
    New Member
    Join Date
    Mar 2015
    Posts
    8

    Default Trouble after DSP5 upgrade

    Working on a 2003 lb7. Ive tuned a Cummins before but this is the first duramax that I've worked on. Truck runs great in stock form. Upgraded to dsp5 and ran the script to populate the maps. Drove the truck without changing anything else and it seemed to run as stock. Which it should. Did a few changes to fuel and timing maps and flashed the ecm. Stock ran fine, then switched up to level 2 but it defueled like crazy. Truck would go down the road but you could put it to the floor and it would just crawl. Checked the units (torque units) and they are all in lbs ft. Any ideas folks?

    Sent from my LG-H910 using Tapatalk

  2. #2
    New Member
    Join Date
    Mar 2015
    Posts
    8

    Default

    Nevermind I figured it out. MAF allowable error was holding it back.

    Sent from my LG-H910 using Tapatalk

Similar Threads

  1. Trouble with V8 upgrade
    By IowaDiesel in forum Diesel
    Replies: 4
    Last Post: June 10th, 2013, 09:16 AM
  2. DSP5 trouble and Reflash problems
    By twistedtx in forum Diesel
    Replies: 2
    Last Post: January 5th, 2011, 08:37 AM
  3. Replies: 0
    Last Post: January 3rd, 2010, 01:17 AM
  4. Trouble loading DSP5 Tune
    By Dmaxx 02 in forum Duramax LB7
    Replies: 6
    Last Post: September 14th, 2009, 06:12 PM
  5. Trouble with V7 upgrade
    By gearheads78 in forum General
    Replies: 7
    Last Post: June 14th, 2007, 07:20 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •