Page 3 of 3 FirstFirst 123
Results 21 to 22 of 22

Thread: Smalll Block 383 Stroker back on the road to completion

  1. #21
    Lifetime Member HellKnightHicks's Avatar
    Join Date
    Mar 2011
    Posts
    268

    Default

    Quote Originally Posted by joecar View Post
    MAF table would be the only thing needing correcting (i.e. do AutoMAF or half of Calc.VET).
    I saw this post earlier just didnt respond. Thats awesome. Thanks for the information its exactly what I needed to know.

    I have the Engine Back and a couple of wiring issues to fix.

    1 the PCM doesnt power off with the key. I'm not sure whats causing that... But every time I need to re-flash I have to pull the battery cable. Plus its killing the battery when it sits. Seems like someone suggested moving a wire. Gonna have to go thread digging for that one.

    My knock sensor doesn't read which is bad. I had some knocking/pinging under strenuous conditions. Going to run a fresh wire and connector to the already replaced knock sensor.

  2. #22
    Lifetime Member
    Join Date
    Mar 2009
    Posts
    746

    Default

    Good to see your priorities are slowly falling back in line.
    1998 GMC Sierra K1500 5.7/4L80E, longtubes, 411 w/COS 5, marine cam/intake, Whipple. 91 octane at 6000'.
    1997 GMC Sierra K3500 7.4/4L80E, 411 w/COS 3, Whipple, small cam.
    2004 Corvette Z06 with longtubes.

Page 3 of 3 FirstFirst 123

Similar Threads

  1. 6l80e shift time completion
    By b18cls1 in forum 6 speed/8 speed RWD/FWD Transmission Tuning (incl T43, T76, T87)
    Replies: 26
    Last Post: June 14th, 2010, 01:58 PM
  2. Need some help with a 383 stroker
    By TransTech in forum Gen III V8 Specific
    Replies: 6
    Last Post: November 22nd, 2007, 04:59 AM
  3. Newbie 383 stroker question
    By TransTech in forum General (Petrol, Gas, Ethanol)
    Replies: 1
    Last Post: November 21st, 2007, 12:36 PM
  4. Stock cube's to 383
    By chevpower in forum General (Petrol, Gas, Ethanol)
    Replies: 3
    Last Post: July 17th, 2006, 08:54 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •