My brand new Moroso 3 vane vac pump took a dump. Had vane material all thru the hoses and pump. Now i know why the guage was not moving from .82 in/hg... lol! I have to figure out why the pump failed but in the meantime i ordered a rebuild kit. Mon i drop the truck off to get full exhaust done finally and then i can resume my tuning. Doesnt make sense to mess around .
That's too bad it failed... I'm curious as to what caused it.
Yeah Joecar same here! Im thinking that b4 i plumbed the pump in i had the plastic intake and exhaust plugs in to keep dirt out. But i noticed they pertruded into the pump. I remember cranking the engine over to check oil pressure in the past. So im thinking when i did that the vanes might have made contact with the plugs and damaged them. I cant think of how else it could have happened? I have a rebuild kit on the way so it should be back up in a day or so and when i get the truck back from exhaust shop ill be back getting her dialed in!!!
Ill take some pics of inside the pump when i break it down.
Joecar i keep getting a p0463 code. In my pics i posted i have them set to no report and mil off. I left the tank vac pressure codes as non emissions in hopes i can record the data from that but the fuel level signal i keep getting a code... Any idea how i can turn that off?
Doing the Rafig as, per the tutorial, do i set up a Histo for each temp threshold and adjust each temp in b4307?
Also still not sure about p0463 code??
For P0463, try setting it to MIL on (and Not-Reported).
Joecar ive been trying to setup this CALC pid for the better part of the day!lol! Can u take a look and see if I have it correct? i dont find it in the scanner? Im setting up for CALC VE. Thanks