Page 19 of 19 FirstFirst ... 9171819
Results 181 to 183 of 183

Thread: Start over,

  1. #181
    Lifetime Member Tinbender59's Avatar
    Join Date
    Jun 2010
    Posts
    289

    Default

    Quote Originally Posted by Tinbender59 View Post
    After a bit of trolling on the forum I found where somebody had opened up their sensitivity on misfires so I opened mine up 100 more points In the RPM range I'm having troubles problem went away.
    P.S. these are back to stock.

  2. #182
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Quote Originally Posted by Tinbender59 View Post
    ok I have gone line by line reading the " Calc.VET: correcting MAF and calculating VE (in single log) " then I read the summary notes. In the Summary Notes there are references to setting PE rich enough to protect the motor, (not in the CALC.VET section). If I read it "all" correctly I am tuning for VE, so if I setup the tune correctly, VE should be disabled, therefore making the "richen up VE a moot point?

    Am I correct in this thought?
    Calc.VET tunes MAF, so it disables VE.
    PE richens regardless of running from MAF or VE.

    Also, somewhere I thought that there were additional, data parameters ( as in B0701) that should be set, does anyone know which ones??
    The Calc.VET thread has all the info you need.
    B0701 cat prot enable: leave enabled if you have cats, disabled otherwise.

    I am coming at this trip as if I had never seen EFILive before, so that I'm not Jaded with miss-conceptions. hopefully get it right this time!!


    P.S. I finally have all of the mechanical and electrical issues solved, she runs really good for not being tuned.
    The mech issues are really important, can't tune around them. Good job
    Last edited by joecar; July 6th, 2019 at 12:20 PM.

  3. #183
    Lifetime Member Tinbender59's Avatar
    Join Date
    Jun 2010
    Posts
    289

    Default

    Cool, thanks Joe

Page 19 of 19 FirstFirst ... 9171819

Similar Threads

  1. Start/Post start issue!
    By IJ. in forum Gen IV V8 Specific
    Replies: 3
    Last Post: September 3rd, 2013, 01:55 PM
  2. Cold start perfect, Warm start flares high
    By samh_08 in forum Gen III V8 Specific
    Replies: 1
    Last Post: May 12th, 2009, 08:36 PM
  3. Cold start great but warm start sucks."Idle
    By mvvette97 in forum Gen III V8 Specific
    Replies: 11
    Last Post: October 25th, 2008, 11:22 PM
  4. The First Start-up!!!!
    By RacerChris in forum Gen III V8 Specific
    Replies: 4
    Last Post: May 1st, 2007, 12:00 PM
  5. No start.
    By curtbriggs in forum General (Petrol, Gas, Ethanol)
    Replies: 45
    Last Post: April 19th, 2005, 11:04 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •