Results 1 to 1 of 1

Thread: Need a new cable OBD to RJ and also a quesiton about DSP5

  1. #1
    Lifetime Member
    Join Date
    Jul 2007
    Posts
    376

    Default Need a new cable OBD to RJ and also a quesiton about DSP5

    1. Need a new OBD2 - > RJ cable for my Flashscan. Recommended source?

    2. If I remove the wiring from the DSP5 cable on a LBZ diesel, will the truck run ok? If so, which tune does it revert to?

    Thanks.

    EDIT: Cancel #1, found my cable.
    Last edited by TFZ_Z06; May 14th, 2019 at 06:11 AM.
    07 Silverado DMax Classic
    02 Z06 LS3 416, 805rwhp, TFS245, Wiseco, Callies Crank/Rods, Iskendarian Lifters, Crower Rockers, FAST102/90, ATI Damper, 1-7/8 Kook's LT, QkTime Shield,Tolle-Fab 8pt
    Old Engine: 1/4mile = 9.6/146 New Engine:?

    EFI Live Tune/Scan v7.5.27, EFI Live Scan and Tune v8.2.23, build 276, BootBlock 2.07.06, FirmWare 2.07.52, 512K RoadRunner (12.14.R), Innovate Serial LC2x2


    COS5/12212156 For 2002 Z06 Manual Vette

Similar Threads

  1. Need new OBD cable for V2
    By Beer99C5 in forum FlashScan V2
    Replies: 3
    Last Post: January 22nd, 2010, 12:36 PM
  2. Obd I??
    By samdweezel05 in forum General (Petrol, Gas, Ethanol)
    Replies: 0
    Last Post: August 2nd, 2008, 11:15 PM
  3. Reading OBD-I w/ OBD-II plug car?
    By Garry in forum General
    Replies: 0
    Last Post: February 27th, 2007, 08:07 AM
  4. Scan/Edit Quesiton
    By lplott in forum General
    Replies: 3
    Last Post: July 19th, 2005, 08:05 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •