Hey There
This is a quick process question.
I am running the V2 as a scanner. When I start my truck and launch the scan 7.5 the first step is to connect this usually lets me select my controller then the buttons come up to record or monitor a scan. Here is the problem when I stop the truck and leave the log running it will pick up where it left off if I restart in under 5 minutes but if
I stop the log before turning off the truck and, or stop the software, and or disconnect the controller or wait longer then 5 minutes to restart the engine I have to go through
a lengthy process to have the V2's cable recognized again. This usually means unplugging the USB and plugging it in with the scan software closed.
eventually I get it back but I must start a new log.
Is there a procedure that can prevent this.
Thanks
D