Results 1 to 6 of 6

Thread: Ad inputs reading the same

  1. #1
    New Member
    Join Date
    Nov 2019
    Posts
    4

    Default Ad inputs reading the same

    Does anyone know a solution as to why the flashscan v1.2 is logging ad1 and ad2 as the same voltage and mimicking each other and causing ad2 to read wrong?

    Does the same thing even with nothing connected to the ad2 input!

    Click image for larger version. 

Name:	20191105_170518.jpg 
Views:	270 
Size:	1.11 MB 
ID:	23063
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	20191103_154745.jpg 
Views:	209 
Size:	1.01 MB 
ID:	23064  

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    How did you wire up...?

  3. #3
    New Member
    Join Date
    Nov 2019
    Posts
    4

    Default

    signal from my innovate lc2 in the ad1
    common ground to chassis in the 2nd pin
    and lentenfelter lnc002 5v output to the ad2 pin

  4. #4
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    So you have the ground from the LNC002 and the ground from the LC-2 connected together and to the middle pin on the FSV1...?

    Are you sure they are both grounds...?

    Disconnect the ground connection from chassis, use actual grounds from each device.

  5. #5
    New Member
    Join Date
    Nov 2019
    Posts
    4

    Default

    they both are running off the single common ground (to the same point as the lc2), they both register different voltages off this earth, and the lc2 also still works without a ground hooked up to the v1.2.

    the LNC002 is earthed via the coil pack harness. do you think this will be the issue? simple as just joining the 2 earths on the centre pin of the v.12?

  6. #6
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Quote Originally Posted by olmatey88 View Post
    ...

    the LNC002 is earthed via the coil pack harness.
    Is this ground connected to vehicle/chassis ground...?

    simple as just joining the 2 earths on the centre pin of the v.12?
    Try this.

Similar Threads

  1. Resolution of V1/V2 A/D inputs?
    By Garry in forum External A/D inputs
    Replies: 3
    Last Post: January 3rd, 2009, 10:56 AM
  2. calibrating ad inputs
    By mr.prick in forum FlashScan V2
    Replies: 4
    Last Post: February 12th, 2007, 03:02 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •