Aem ben maps

[hsv084]

Hi All,

Just looking for some direction. I am trying to get a MAP working in V8 Scan for my AEM canbus wideband sensor.
The wideband reads no worries. I created a calc pid which function tested ok. If I right click for more info on the pid in the selected pid page the precision is showing 0
but in the configure pid page where I created the pid it show a precision of 3. Not sure if this is the cause of my issue but after logging for a little bit all I get in the MAP results are 1's & 2's.
Pics attached to illustrate. Any help to correct would be appreciated.

[joecar]

Check the data cell precision in the map properties.