Results 1 to 5 of 5

Thread: DTC problem

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    New Member
    Join Date
    Dec 2009
    Posts
    5

    Default DTC problem

    -On My LSX 454 with E38, I keep getting MIL turning on with various codes.(see below) The mil is off on restart, but comes back on after idling for a few minutes.
    I went through DTC list and disabled non pertinent codes but still keep getting MIL. I did a complete reflash that didnt help.
    Any thoughts? Thanks



    ---Confirmed Trouble Codes Scan Report----
    0 Confirmed Trouble Codes:
    ----Pending Trouble Codes Scan Report----
    0 Pending Trouble Codes:
    ----Permanent Trouble Codes Scan Report----
    8 Permanent Trouble Codes:
    1. U25D4
    Check report for description.
    2. P3BAA
    Check report for description.
    3. B2AAA
    Check report for description.
    4. C0341
    Check report for description.
    5. B2A00
    Check report for description.
    6. P054C
    Cold Start "B" Camshaft Position Timing Over-Advanced Bank 2
    7. C0D54
    Check report for description.
    8. P2626
    O2 Sensor Pumping Current Trim Circuit/Open Bank 1 Sensor
    Last edited by dsrour; February 20th, 2020 at 06:02 AM.

Similar Threads

  1. Problem with DTC PO342 Camshaft Position sensor circuit low
    By LSXstart in forum Gen III V8 Specific
    Replies: 10
    Last Post: December 3rd, 2010, 02:35 PM
  2. DTC's from v2 to lap top and cures to DTC's
    By 68problemchild in forum FlashScan V2
    Replies: 0
    Last Post: October 2nd, 2010, 04:08 AM
  3. V2 Firmware DTC problem?
    By Cougar281 in forum FlashScan V2
    Replies: 2
    Last Post: October 2nd, 2010, 12:50 AM
  4. DTC I've never seen
    By RPM Motorsports in forum Duramax 06 LLY / 06+ LBZ & LMM
    Replies: 3
    Last Post: August 18th, 2008, 11:20 PM
  5. PID Problem w/BBB - Asked by Cougar 281 (FRPDES problem)
    By Jasondt2001 in forum FlashScan V2 BB Logging
    Replies: 2
    Last Post: March 23rd, 2008, 01:02 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •