Results 1 to 4 of 4

Thread: Injector scaling for high fuel trim

  1. #1
    Junior Member
    Join Date
    Oct 2016
    Posts
    40

    Default Injector scaling for high fuel trim

    2002 5.3l, 4l60e, Jeep CJ5
    return type fuel system with corvette regulator filter (non referenced) @ 58 psi
    Bosch 9186340 injectors
    Professional Products Power+Plus intake

    I tuned the vehicle with the injector data that was supposed to be for the Bosch Injectors, it would not start
    I then tuned the vehicle with the stock injector tune and it starts and runs fine, but has a rolling idle and the STFT and LTFT are high. I disabled LTFT but when they are enabled they stay at 25.

    Can somewhere direct me what to do with the injector data to solve this, or does anyone have data for the Bosch 9186340 (0280155831) injectors. ThanksLS1B_0032.eficj5 1.ctz

  2. #2
    Senior Member
    Join Date
    Dec 2016
    Posts
    131

    Default

    I hope I am not bearer of bad news but it sounds like the injectors are junk. Are these ebay/chinese injectors? I have seen plenty of really bad injectors from there. I have injector cleaning and flow testing equipment in house. It sucks to guess at stuff like that, ck in your area to see if someone can check them. The biggest thing I have seen is the ebay/chinese injectors won't handle any extra fuel pressure. Those injectors stock were for 3 bar(43.5 psi). The LS is 4 bar(58psi).

    The next bad news... it is few and far between to find a good vette filter/regulator anymore, even in an ac delco box. I've seen lots fail as well as a lot of them with much higher pressure. I have quit using them and now mount a regulator and filter on the frame rail(in trucks mainly as it makes for an easy "kit").

    I wish you luck and let us know what you find.
    -Carl

  3. #3
    Junior Member
    Join Date
    Oct 2016
    Posts
    40

    Default

    This is a friends vehicle. He said he bought them off ebay, they were supposed to be remans.

  4. #4
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    What are the flow specs on the injectors (flowrate at what pressure)...?

    How close are they to the original injectors...?

Similar Threads

  1. E38 High Injector Duty Cycle and High Map
    By nchristian in forum E37, E38 & E67 PFI ECM's
    Replies: 1
    Last Post: May 24th, 2017, 04:09 AM
  2. Injector scaling.
    By PRAY in forum FlashScan V1
    Replies: 4
    Last Post: June 24th, 2011, 09:25 AM
  3. Where is the injector scaling table?
    By PRAY in forum Gen III V8 Specific
    Replies: 2
    Last Post: January 2nd, 2009, 12:34 PM
  4. Fuel Trim Cell 10
    By eboggs_jkvl in forum General (Petrol, Gas, Ethanol)
    Replies: 7
    Last Post: December 20th, 2005, 10:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •