Results 1 to 3 of 3

Thread: LS1 reluctor wheel

  1. #1
    Junior Member
    Join Date
    Oct 2007
    Posts
    48

    Default LS1 reluctor wheel

    A question about the position relationship of the crank reluctor wheel to the crank position sensor.
    When the top dead centre falling edge on the reluctor wheel passes the crank position sensor at what position on the face of the sensor generates the top dead centre signal.
    In the face of the crank angle position sensor there appears to be two embedded sensor bars at right angle to the reluctor wheel approximately 4mm apart when setting up TDC for installation on a non LS1 engine does anyone know what part of the sensor is the correct position location for setting up TDC.

    Thanks.

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    Hmmm...

    I'm adding this in case it helps to figure it out:

    Click image for larger version. 

Name:	CKP CMP waveform relationship.png 
Views:	165 
Size:	32.4 KB 
ID:	23245

  3. #3
    Junior Member
    Join Date
    Oct 2007
    Posts
    48

    Default

    Quote Originally Posted by joecar View Post
    Hmmm...

    I'm adding this in case it helps to figure it out:

    Click image for larger version. 

Name:	CKP CMP waveform relationship.png 
Views:	165 
Size:	32.4 KB 
ID:	23245
    joecar...Thanks for the response, I am familiar with the PicoScope trace and the position of TDC on the reluctor wheel. I took a guess and set up the reluctor wheel TDC position in the middle of the sensor it now appears that this is a few degrees out and I will now have to reposition the reluctor wheel accordingly.
    Again thanks for your response.
    Last edited by Yortt; April 13th, 2020 at 04:07 PM.

Similar Threads

  1. 58 tooth reluctor wheel
    By NASABlue in forum General
    Replies: 1
    Last Post: March 2nd, 2015, 03:31 AM
  2. 58 tooth reluctor wheel in an 04' GTO?
    By PRAY in forum Gen III V8 Specific
    Replies: 3
    Last Post: June 12th, 2014, 02:51 PM
  3. Is it possible to run LS2 58x reluctor with LS1 computer???
    By Hideintire in forum Gen III V8 Specific
    Replies: 6
    Last Post: May 6th, 2014, 02:11 AM
  4. 4x Reluctor
    By doubledip in forum General (Petrol, Gas, Ethanol)
    Replies: 5
    Last Post: September 10th, 2010, 01:55 AM
  5. Holden V8 - reluctor 24x with LS1 PCM
    By Batman in forum Conversions / Aftermarket Parts
    Replies: 4
    Last Post: July 21st, 2009, 04:36 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •