Results 1 to 3 of 3

Thread: VE smoothing function not working as it did before update

  1. #1
    Junior Member TorqueMonster007's Avatar
    Join Date
    Aug 2013
    Posts
    47

    Default VE smoothing function not working as it did before update

    Just updated to V8 3.5 and associated V7.5. I have noticed that on E38,E67 and E92 ECMs that both V8 and V7 editors will not save small commanded VE changes but will only average out large changes with associated cells. Am I missing something with the new update that I haven't really noticed before? For instance if I take a cell in a stock VE and just put "0" it will not command "0" for that cell but will lower it and average down the cells around it. I noticed this when I was trying to adjust and smooth a VE in an E38 and it was not saving my commands. Any help with this? FWIW: V2 is connected and reading/ working properly at this time. It is not in "Demo" mode. Bootblock and Firmware are also up to date. Also tried saving as under a new name with same results. So if you were to smooth a small dip or peak it will not allow you to as I was trying to do.
    2019 2500HD Denali Duramax L5P
    2016 LML 2500HD Duramax High Country with a little help
    2018 Yukon with a little V2 love for the wife

  2. #2
    Junior Member TorqueMonster007's Avatar
    Join Date
    Aug 2013
    Posts
    47

    Default

    Anybody have anything? Suggestions? Was there something that defaulted with the update I wasn't aware of?
    2019 2500HD Denali Duramax L5P
    2016 LML 2500HD Duramax High Country with a little help
    2018 Yukon with a little V2 love for the wife

  3. #3
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,074

    Default

    See your other thread on this topic.

Similar Threads

  1. Smoothing the VE Table?
    By Rich Z in forum Gen III V8 Specific
    Replies: 44
    Last Post: January 30th, 2013, 10:58 AM
  2. table smoothing
    By gigabrock in forum Duramax LB7
    Replies: 0
    Last Post: October 5th, 2012, 07:08 PM
  3. VE Smoothing
    By nonnieselman in forum Gen III V8 Specific
    Replies: 15
    Last Post: September 8th, 2008, 07:19 AM
  4. What are your smoothing techniques
    By Dirk Diggler in forum General (Petrol, Gas, Ethanol)
    Replies: 26
    Last Post: June 23rd, 2005, 12:08 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •