Results 1 to 3 of 3

Thread: 2 bar Map question

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Junior Member
    Join Date
    Mar 2014
    Posts
    42

    Default 2 bar Map question

    Hi,
    hope someone could chip in..
    just installed a 2 bar map sensor
    got on the box Auto sensor standard parts PRC, OEM LS 2 bar
    Think it was sfi...?
    Anyway with old sensor key on Map was reading 101kpa.
    so installed new and key on with 190 in settings as per COS3 tutorials showed 81kpa....
    210 showed 88 kpa.
    240 showed 99 kpa.
    245=101kpa as old stock 1 bar sensor.

    Sometimes do they need that much adjustment?
    hoping to drive it tomorrow to start logging
    regards
    gavin

  2. #2
    Joe (Moderator) joecar's Avatar
    Join Date
    Apr 2003
    Posts
    28,403

    Default

    There is a MAP scaler that you have to set so that your MAP shows up with the correct value.

  3. #3
    Junior Member
    Join Date
    Mar 2014
    Posts
    42

    Default

    Hi Joe,
    Hoping you would reply.
    Yes i used the scaler to set engine off key on value to 101kpa.
    Think i may have a 2.5 bar sensor as results in first post.
    With my vac pressure pump at 50kpa(vacuum) i get around 50 kpa vac in scanner, but if i put pressure in it stops reading at 105kpa. I am using correct map pid (i think ....) so from searching posts here and on LS1tech, it seems if the engine is not running then the map connected to my pressure pump wont read past 105kpa anyway....
    I have a post on ls1tech with screenshots etc.
    I havnt adjusted the offset value in tune though (think set to 10 atm) as not sure what to do with that
    Regards
    Gav

Similar Threads

  1. 2 bar map question 2010 Camaro
    By beaukz28 in forum Forced Induction and Nitrous Oxide (N20)
    Replies: 2
    Last Post: January 16th, 2013, 04:37 AM
  2. COS 3.3 bar map only reading 2.5 bar
    By BAD BOB in forum FlashScan V2
    Replies: 0
    Last Post: August 8th, 2011, 11:27 AM
  3. 3 Bar MAP sensor doesn't work with 3 Bar scaling!
    By Redline Motorsports in forum General (Petrol, Gas, Ethanol)
    Replies: 23
    Last Post: April 27th, 2010, 04:21 PM
  4. Question about 2-bar MAP sensor
    By SSpdDmon in forum Gen III V8 Specific
    Replies: 8
    Last Post: September 21st, 2009, 04:42 AM
  5. COS5 With A 2 Bar Map Sensor Question
    By ForcefeedWS6 in forum Custom Operating Systems
    Replies: 6
    Last Post: August 23rd, 2007, 08:39 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •