Results 1 to 2 of 2

Thread: CM2200 cross model year compatibility

  1. #1
    Member
    Join Date
    Jan 2020
    Posts
    53

    Default CM2200 cross model year compatibility

    I have had a few trucks come in for tune updates, trucks were previously tuned by someone else.

    The trucks had different model year calibrations, like a 2010 tune in a 2011 or a 2012 in a 2011.

    Is this possible? I was under the impression that each model year needed its specific calibration.

    Can I use a 2012 in a 2010 for example?

  2. #2
    Junior Member
    Join Date
    Oct 2014
    Posts
    28

    Default

    See post 17 & 18 on the thread CM2200 bench harness pinout lower down on page one or towards top of page two of this forum. I had asked a similar question regarding a CM2200 C&C ECM that I got to replace a Pickup CM2200 ECM. I overwrote the C&C with a stock 2010 file from the old Tune Depot link. It worked fine. I would read the Cummins 6.7 CM2200 CSP5 users guide that EFILive has regarding flashing these ECM's that have prior tunes loaded on them. Towards the beginning it addresses potential problems with EFILive clashing with other tuners modifications.

Similar Threads

  1. Replies: 0
    Last Post: December 5th, 2016, 12:09 PM
  2. Replies: 2
    Last Post: May 18th, 2015, 07:58 AM
  3. 06 model year?
    By DWS6 in forum General (Petrol, Gas, Ethanol)
    Replies: 6
    Last Post: September 3rd, 2006, 07:34 AM
  4. What year model?
    By Blacky in forum General (Petrol, Gas, Ethanol)
    Replies: 28
    Last Post: July 8th, 2004, 11:02 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •