Results 1 to 3 of 3

Thread: CM2200 Manual Calibration question

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. September 24th, 2021 #1
    s4door
    s4door is offline
    Junior Member
    Join Date
    Oct 2014
    Posts
    28

    Default CM2200 Manual Calibration question

    I have opened several 2010 CM2200 base files that say they are a manual calibration but they have all of the 68RFE parameters for making changes to the transmission. I also have opened a couple of 2011 and one 2012 base files that also state they are a manual calibration and they do not have the 68RFE parameters. I was wanting to use a manual calibration because I do not want the ECM looking for the 68RFE because I have a 2006 Allison 1000 using a separate TCM for it. Should I use the ones that don't have the 68RFE parameters? I've attached a couple of examples.
    Attached Files Attached Files
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. How to load just manual trans calibration to auto calibration tune?
    By lsx523 in forum Petrol / Gas
    Replies: 1
    Last Post: February 24th, 2014, 10:33 AM
  2. os calibration swap 06 megacab california manual
    By relentless addiction in forum Cummins 5.9L
    Replies: 4
    Last Post: September 24th, 2013, 04:22 AM
  3. Manual 4l80 swap question
    By phantom in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 11
    Last Post: October 25th, 2011, 01:34 PM
  4. anyone have a 4.8 manual calibration??
    By DURAtotheMAX in forum Gen III V8 Specific
    Replies: 4
    Last Post: August 22nd, 2009, 06:39 PM
  5. How to change an auto calibration to a manual one?
    By ringram in forum General (Petrol, Gas, Ethanol)
    Replies: 4
    Last Post: November 7th, 2005, 12:12 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules