Results 1 to 3 of 3

Thread: Initial flash of T42

  1. #1
    Junior Member
    Join Date
    Jul 2004
    Posts
    28

    Default Initial flash of T42

    Replacing the transmission controller on a 2008 Silverado, I uploaded the calibration from my old one and tried to flash the new one but got an error saying the OS was different. Do I have to find a newer calibration to match the new module? I've been looking around but haven't found anything. Thanks for any help or advice.

    EDIT: I think I need a T42 stock tune (2008 Silverado) that uses OS 24252617. If anyone can point me in the direction of one I would appreciate it, thanks.
    Last edited by frodo84; December 26th, 2021 at 08:20 AM. Reason: Found more information

  2. #2
    Junior Member
    Join Date
    Apr 2021
    Posts
    12

    Default

    I've tried it many times with no luck. The OS is pre programmed into the controller. GM MDI and TDS web is the only way to do it on your own. I trailer them to a dealer when I rebuild transmissions and /or replace the TCM.
    I think I've still got a flat spot on my forehead from beating my head on the wall trying this one over and over.

  3. #3
    Junior Member
    Join Date
    Jul 2004
    Posts
    28

    Default

    Thanks for the reply. I had to get a controller from a third party, programmed to my VIN.

Similar Threads

  1. Old T42 tune to new T42 requires updated operating system, segment swap?
    By 68problemchild in forum 4speed RWD/FWD Transmission Tuning (incl T42)
    Replies: 3
    Last Post: April 28th, 2019, 11:27 AM
  2. Initial Timing Tune
    By willn in forum Gen III V8 Specific
    Replies: 0
    Last Post: July 21st, 2014, 12:55 AM
  3. Help On Initial Startup
    By Dale in forum General (Petrol, Gas, Ethanol)
    Replies: 10
    Last Post: November 10th, 2007, 08:08 AM
  4. Initial 402 tuning?
    By Bruce Melton in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: July 19th, 2006, 04:26 AM
  5. Initial Releas of Flashscan
    By jfpilla in forum General (Petrol, Gas, Ethanol)
    Replies: 2
    Last Post: November 22nd, 2004, 10:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •