Results 1 to 1 of 1

Thread: Innovate DLG-1 Setup for V2 Data logging

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    New Member
    Join Date
    Feb 2021
    Posts
    2

    Default Innovate DLG-1 Setup for V2 Data logging

    I have an Innovate DLG-1 that im trying to setup to my v2 through the analog outputs and cant get it to read. AFR is still 0.0. Not sure if i have it setup correctly bc there is not much info on it from what i have found. Never logged with one before. also can i monitor both banks from the dlg-1? it seems like i can but i cant figure out how to set that up either. it has a brown and yellow wire for the 5v out put coming out of the DLG-1 which are the positive wire to the 5 volt plug and the other is ran to ground on each one. Also what is the correct output voltage supposed to be set too? it is defalted to 0 volts at 7.35 AFR and 5.0 volts at 22.39 AFR. the only pid i have selected is external wide band afr. i also cant use the V8 at all bc it locks ups on me and haven't been able to use it in years no matter what updates i try so i can only use live scan V7.5 and live tune V7.5 to data log and load tunes so i either need to do my changes there or on the V2 itself. Any and all help would be greatly appreciated. Thanks
    Last edited by wagone; September 21st, 2022 at 12:25 PM.

Similar Threads

  1. Serial Logging with Innovate LC-2, DLG-1, and MTX-D
    By tadams72 in forum External A/D inputs
    Replies: 11
    Last Post: August 25th, 2019, 10:20 PM
  2. Replies: 9
    Last Post: November 7th, 2018, 01:07 PM
  3. DLG-1 Problems.
    By Big511 in forum Gen III V8 Specific
    Replies: 2
    Last Post: May 2nd, 2017, 08:49 PM
  4. Replies: 4
    Last Post: April 5th, 2017, 04:54 AM
  5. Replies: 9
    Last Post: May 5th, 2016, 05:52 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •