Been trying to get my s10 dialed in. It's running a cammed 5.3 engine. It seems to just barely tap the rev limiter right at the 1-2 shift at Wide open. My limiter is set to 6200 so hate to bump it up any more. What table can I change in the trans to make it shift just a bit sooner? Funny thing is I had an old wore out 6.0 in it before and it never did hit the limiter during the shift but this 5.3 does. this new engine seems to rev way faster than the old 6.0. It was down on power compared to this new engine. I would guess it's just revving too quick in first for the trans to keep up and make the shift in time. Figued I could command it to shift a little sooner to hopefully get the shift just below the limiter. The trans is a 4l80 as well.