2011 LML Cruise Control

[Lennydmaxguy]

Recently tuned a "lightweight" LML, and lost cruise control afterward. The truck had an H&S programmer previously, and cruise worked with it. These are the file segments:

Segment Description Part# Checksum Comments
Boot Software 12646251 $60F19343
Secondary Operating System 12646250 $4FE0608C
Main Operating System 12646249 $1167F5E0
Engine 12655862 $5B04914D
Speedometer 12646363 $373AA8B5
System 12655886 $CBF1C486
Fuel System 12646324 $EB6F405E
Engine Diagnostic 12655870 $3509C5C4
Engine Operation 12655864 $B1AE0F45

I've tried various combinations under Vehicle Options > Parameters, but no luck so far.

Can anyone help me out here? I can send the tune in private message, but I prefer not to post it.

[Omega_5]

I had this same thing happen on OS 12649244. I had to fiddle with the CAN communications to get it to work.
It ended up being one of the "BLOx" sensors. Turned communication back on, and the cruise started working again.

[Lennydmaxguy]

Thanks. I'll try that.

[Lennydmaxguy]

Finally got to work on the truck again. Ended up being some speed limiters I set wrong. I believe B0603 is for cruise control, if I'm not mistaken. This is how I ended up setting the table

[X-Force]

I had this same thing happen on OS 12649244. I had to fiddle with the CAN communications to get it to work.
It ended up being one of the "BLOx" sensors. Turned communication back on, and the cruise started working again.

im having problems with it working but turns off by itself in diffrent time intervalls.


you know exactly what Nox sensor CAN table to re activate?

[Omega_5]

It's best to leave them all enabled, unless you're getting dash messages.